Page 1 of 1

Primer for plates

PostPosted: Thu Aug 31, 2017 10:55 pm
by longtimefan
Do you use the 3m primer for plates if not what do you use?

Re: Primer for plates

PostPosted: Sat Sep 16, 2017 7:01 am
by george3636
Hello, What type or brand of printing tape are you using?

Re: Primer for plates

PostPosted: Sat Sep 16, 2017 9:40 am
by longtimefan
Tesa, green.

We have primer from them, was wondering what else is around

Re: Primer for plates

PostPosted: Mon Sep 18, 2017 10:24 am
by george3636
I was using a permanent marker but I switch back to 3M tape have little or no issues with plate lifts.

Re: Primer for plates

PostPosted: Mon Sep 18, 2017 10:44 am
by longtimefan
Yup have used that

Re: Primer for plates

PostPosted: Wed Nov 08, 2017 12:25 pm
by barb
Same here, 3M primer for both 3M and Tesa tapes. Permanent marker when we run out of primer, also (altough my colleague noted the red marker fits better than black, no clue why :smile: )

Re: Primer for plates

PostPosted: Fri Nov 10, 2017 9:07 pm
by longtimefan
Heat gun on plate breaks.. Heat up sticky back (with plate already laid) to re melt adhesive as it is heating up rolling edges of plate.. Takes 3 secs
To heat and roll