Continuous roll plate making

Ask or answer questions related to the flexo prepress environment.

Moderator: Frank Burgos

Continuous roll plate making

Postby Ali » Wed Aug 07, 2019 7:12 pm

I am looking for some information on how should I prepare plates for a continuous roll job. I have heard the plate should not be a regular rectangle, but not sure how and at what angle the plate should be cut. Any help is very much appreciated.
Ali
 
Posts: 12
Joined: Mon Jun 11, 2018 7:29 pm

Re: Continuous roll plate making

Postby guy de cafmeyer » Mon Aug 12, 2019 2:36 am

The easiest is to take an old cylinder / sleeve , and have it rubber covered and engraved ... to the correct diameter of an existing gear size .. ?
guy de cafmeyer
 
Posts: 71
Joined: Tue Apr 14, 2015 3:13 am


Return to Prepress

Who is online

Users browsing this forum: No registered users and 1 guest