ECRM-No Image on film

Ask or answer questions related to the flexo prepress environment.

Moderator: Frank Burgos

ECRM-No Image on film

Postby GARR » Mon Jun 21, 2010 1:26 pm

Using an ECRM Mako 46 film setter, we are not getting an image on the exposed film. The jobs are going through the correct size, but no image is being burned into the film. If anyone has any ideas on what may be the culprit, I would appreciate the help.

Thank you.
Posts: 1
Joined: Mon Jun 21, 2010 1:20 pm

Re: ECRM-No Image on film

Postby exflexo » Thu Jun 24, 2010 1:07 am

First, rule out bad film and chemistry. Once that is done, run an internal exposure test from the imagesetter, to rule out anything on the front end that is before the Rip. If the problem still persists, and it's not an exposure setting that got screwed up... it sounds like a dead laser or dead power supply. Time to call a repair guy...
Posts: 222
Joined: Fri Sep 21, 2007 5:01 pm

Return to Prepress

Who is online

Users browsing this forum: No registered users and 1 guest