UV lamp issues

Ask or answer questions related to the flexo pressroom environment

Moderator: Frank Burgos

Post Reply
Posts: 1
Joined: Mon Sep 12, 2016 3:04 pm

UV lamp issues

Post by ROBMOD »

Good morning,

I was asked to replace a 11" AAA uv lamp because there were curing issues at the edges of the web.

I installed a new lamp, allowed it time to reach temperature, and the run continued without any issue.

At the next stop the lamp went into a under current fault. I cleared the fault and restarted the lamp. It ran again without issue until the next stop.
I then tried a new lamp from a different vendor, and had the same issue.

I just reinstalled the original lamp (curing issue) and it works normally.

Has anyone seen a similar issue? Any suggestions?
Post Reply