Page 1 of 1

create icc profile

PostPosted: Fri Jul 14, 2017 3:07 am
by kamyabkavianiflexo
What need for create icc profile for narrow web flexography?
Please advice or guidance me what do i do?

Re: create icc profile

PostPosted: Tue Jul 18, 2017 1:00 am
by richflexo
Hi there,

You'll need some software and some hardware. It will also depend on your plate making and rip equipment as well. But the hardware to read your charts is fairly standard. We use an Xrite i1i0 to read P2P charts that make our plate curves and then when those are printed we put on an IT8.4 chart that will make your ICC profile.

Software - curve 3 or 4 by chromix (makes curves for plates)
Hardware - Xrite i10 table (reads charts)
Resources - FIRST 5.0 (literature)

It's a science so get your production and pre press department on the same page before you start and build standards otherwise you'll be battling each other.

There is a lot more than that but read up on all the products and visit fore more info.

Re: create icc profile

PostPosted: Wed Jul 19, 2017 11:52 pm
by barb
Do you make plates in-house or do you have a supplier who does it for you?

Re: create icc profile

PostPosted: Sun Jul 30, 2017 2:57 am
by kamyabkavianiflexo
yes, we have supplier for make plates